[joemd]

Thank for the video, much appreciated.

Due to the set up of my apartment I’ve limited ability to move my modem around (long story) and thus didn’t have an ethernet cable long enough to reach from the lounge room where the RPi is to the modem. Luckily, I found THIS article and video explaining how to connect to the RPi remotely from my laptop while it was plugged into my modem away from the TV

[joemd]

I did the above and it seems I’ve managed to get the X-Box 360 one working. However, the light around the X-Box logo button continues to flash. Is this supposed to happen? It’s not a big issue, just wondering. I like that I’m able to use combos to get into menus and stuff too. Thanks for the help , dankcushions!

This is probably a silly question, but does the RPi need to be on-line for the Scrapper to work? I managed to download the driver for the 360 pad connecting to the RPi remotely from my laptop. I’m assuming the same would be possible here? I do plan on getting a wifi dongle at some point though.

I’ve not tried the Mega Drive controller again yet.

[joemd]

I did leave select blank. Perhaps I could use the “mode” key?

I was able to get xboxdrv downloaded to the Rpi, but the set up page of the Wiki is SO confusing! I’ve done everything up to the RetroPie configuration step which I’m trying to work through now but I’ve no idea if I’m doing it right. 0_o

[joemd]

Erroneous post.

[Author]

Posts