I updated retropie from source. I use a USB controller. Afterwards, found all my settings for my hotkeys still work for the SNES emulator and everything is fine.
But then I checked my retroarch config…both the “all” and the SNES specific, and a couple ones that weren’t labeled as other emulators.
None of them had the hotkey setup, nor any of my settings. I had read the configurations would get overwritten, so I was surprised to find my save/load state buttons still worked. Now I’m concerned as to where it’s getting its commands from.
Any ideas where else to look?
Viewing 1 post (of 1 total)
The forum ‘Controller Configuration in RetroPie’ is closed to new topics and replies.
Necessary and Functional
These cookies are placed to make it possible to analyze this website (with Google Analytics) and optimize for the purpose of a.o. the usability.
Cookie names: _ga, _gat, _gid
These cookies are placed to show advertisements (of Google AdSense) and to get these close to your interest.
Cookie names: id, IDE, FLC, DSID, SNID, NID
These cookies are required to show the cookie notification bar, remember your cookie acceptance choice and apply this choice.
Cookie names: privacy_embeds, wpca_consent, woocommerce_cart_hash, woocommerce_items_in_cart, wp_woocommerce_session_, wp-settings-1, wp-settings-time-1