Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • lasergecko
    Participant
    Post count: 16

    Hi,

    While I’m waiting to order and install my arcade controls, can you still use USB controllers after the ControlBlock and binaries are installed or does the ControlBlock take over completely?

    I’d like to start using the Power Switch function while I’m waiting.

    Thanks!
    Jason

    minipax
    Participant
    Post count: 4

    I’m using two NES controllers via CB, and planning to use two usb SNES and two wired xbox 360’s depending on what emulator I’m using (and maybe some usb N64 in the future).

    Currently I’m looking into this post to make the mess work, if it’s even possible.

    edit: short answer is yes, as long as you don’t mind figuring out which controller is where etc.

    petrockblog
    Keymaster
    Post count: 1827

    The ControlBlock service installs two gamepads which use the CB as input. Any other gamepad that is, e.g., connected via USB is detected as additional gamepad in the operating system and they do not interfere with each other.

    lasergecko
    Participant
    Post count: 16

    Thank you for the info. I finally got a chance to attach it and found that out.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.