Homepage › Forums › RetroPie Project › Everything else related to the RetroPie Project › RPi2 image and install by setup.sh

Tagged: ,

  • This topic has 2 replies, 2 voices, and was last updated 9 years ago by Anonymous.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 03/26/2015 at 11:50 #92683
    Anonymous
    Inactive

    version: 2.6

    before setup.sh:
    snes work fine, but display resolutions is very low, and I don’t know how to configure that. I cannot find out where file is.

    after setup.sh:
    mame/snes work fine, but no any sound.

    other error:
    before setup.sh + install independent
    /opt/retropie/supplementary/runcommand/runcommand.sh line 283 _SYS_ command not found
    All game cannot start.

    any solutions?

    03/26/2015 at 13:37 #92688
    petrockblog
    Keymaster

    after updating do a full binary install.

    03/27/2015 at 06:54 #92789
    Anonymous
    Inactive

    Solved.

    after updating, edit /boot/config.txt
    hdmi_drive=2
    and reboot, work fine.

    “sudo raspi-config”
    audio output set to hdmi.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Everything else related to the RetroPie Project’ is closed to new topics and replies.