Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Heres my Small Retropi Project.
Button triggers On/off Using this http://www.forum-raspberrypi.de/Thread-tutorial-hoch-und-runterfahren-mittels-taster-incl-status-led?page=11 Soldering.
Case is a 3d Printed Mini Nes.
Whats left is a 3d printed Sd card holder in Cartridge form :-)
International orders are likely subject to delays due to the COVID-19 pandemic.These may be caused by changes in transport procedures, changes in international transport and/or changes in delivery procedures in the destination country. See also the information from Deutsche Post. Dismiss