- mistrkParticipant07/07/2015 at 23:20Post count: 4
I had the opportunity to work with a cutter during training for my job, so I decided to begin work on a project I’d been dreaming up for a few months now.
It’s got a Raspberry Pi 2 powering it, and I’m using an X-Arcade joystick box for the controller.
You can view the gallery of progress shots at this link.bitbytepixelspriteParticipant07/08/2015 at 00:18Post count: 51
Is it just a HDTV mount on the back? So you could up the tv if you wanted?mistrkParticipant07/08/2015 at 00:21Post count: 4
Yep! It pulls out from the back about 8″ too. Unfortunately it doesn’t turn 90 degrees, but I could replace the mount as well as the TV if I wanted.bitbytepixelspriteParticipant07/08/2015 at 06:22Post count: 51
That would be sweet *Swivel* time for shmups!daddarmParticipant09/22/2015 at 17:52Post count: 1
I like your setup there. Is the coin door functional? If so how did you connect that to the raspberry? thanks
- You must be logged in to reply to this topic.