Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • drakaen391
    Participant
    Post count: 33

    While Pi 3 is on its way…

    Thought I would share my project and get any feedback…

    Photos below and will be updating as the project continues

    It is built out of 1/2 in birch plywood

    The final dimensions will be +\- 2mm. 10.3cm tall 25x25cm

    I will have a feature list added in a little bit

    [attachment file=”image.jpg]
    Installed power supply for cooling system in box

    drakaen391
    Participant
    Post count: 33

    [attachment file=”image.jpg”]

    Got all the pieces except the screws for the Pi board…

    They temp is running under 100 degrees F at standard load… And only 91 at idle

    drakaen391
    Participant
    Post count: 33

    Moved to New Forum

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.