N64 controller

[tabarnak]

Hello, it’s very hard for me to properly configure the n64 controller. (English is not my first langage)
I may be wrong but I believe this config is wrong: /opt/retropie/emulators/retroarch/configs/USB_Gamepad.cfg

The file look like this:
input_device = “USB Gamepad ”
input_driver = “udev”
input_b_btn = “2”
input_y_btn = “3”
input_select_btn = “8”
input_start_btn = “9”
input_up_axis = “-1”
input_down_axis = “+1”
input_left_axis = “-0”
input_right_axis = “+0”
input_a_btn = “1”
input_x_btn = “0”
input_l_btn = “4”
input_r_btn = “5”

input_enable_hotkey_btn = “8”
input_exit_emulator_btn = “9”
input_menu_toggle_btn = “0”
input_load_state_btn = “4”
input_save_state_btn = “5”

[tabarnak]

up

[straedom]

Well… heres mine, I just got it working, but its a N64 Controller Via GPIO.. I dont know if that matters… Also, my sensitivity for my Analog stick doesnt seem sensitive enough, but I dont see a setting for that.

Hope this helps…

input_device = "N64 controller"
input_driver = "udev"
input_b_btn = "2"
input_y_btn = "5"
input_select_btn = "0"
input_start_btn = "9"
input_up_btn = "h0up"
input_down_btn = "h0down"
input_left_btn = "h0left"
input_right_btn = "h0right"
input_a_btn = "1"
input_x_btn = "6"
input_l_btn = "7"
input_r_btn = "8"
input_l2_btn = "5"
input_r2_btn = "4"
input_l_x_plus_axis = "-0"
input_l_x_minus_axis = "+0"
input_l_y_plus_axis = "-1"
input_l_y_minus_axis = "+1"
input_enable_hotkey_btn = "0"
input_exit_emulator_btn = "9"
input_menu_toggle_btn = "6"
input_load_state_btn = "7"
input_save_state_btn = "8"
input_reset_btn = "2"
input_state_slot_increase_btn = "h0right"
input_state_slot_decrease_btn = "h0left"

[Author]

Posts