Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • Anonymous
    Post count: 2


    I have installed retropie 2.6 by burning image from (raspberry pi 2) using win32diskimager

    Installation was completed and I was able to load retropie and configured my xbox 360 controller to control it. However, when I look through the emulator list, I only saw about 3-5 available emulators (IBM, apple 2, mame or something like that). I did not see other emulators such as PSX, N64, SNES, etc. In addition, I have also gone to retropie setup and ran the binaries installation, but this did not help at all. Did I miss a step? or, is the reason why it is not showing simply because I don’t have any ROMs inside the respective emulators? Please advise, thanks!

    Post count: 1858

    There are a few emulators that show up by default but it is configured so that when you add a rom to its respective folder, that emulator will then show up in emulationstation (you’ll have to exit out of emulationstation and go back in or reboot in order for changes to make effect if you add the roms through winscp while emulationstation is running.)

    See this playlist for details on setting up retropie 2.6.

    see the updated Wiki as well if you have any emulator specific issues:

    Post count: 2

    You’re the man! so I was not really far off from the answer. I’ll check out the video. Thanks for the help!

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.