Before I acquire the GPIO adaptor I was wondering if anyone had successfully hooked it up to an original SNES controller connector plate yet (the one that would normally be hooked up by a ribbon cable to the SNES mobo)?
Would you need to remove the PCB and wire straight to the pins as normal or is there other shenanigans required? Failing that, is there any way to make the original PCB/ribbon combo work with the Raspberry Pi at all?
Necessary and Functional
These cookies are placed to make it possible to analyze this website (with Google Analytics) and optimize for the purpose of a.o. the usability.
Cookie names: _ga, _gat, _gid
These cookies are placed to show advertisements (of Google AdSense) and to get these close to your interest.
Cookie names: id, IDE, FLC, DSID, SNID, NID
These cookies are required to show the cookie notification bar, remember your cookie acceptance choice and apply this choice.
Cookie names: privacy_embeds, wpca_consent, woocommerce_cart_hash, woocommerce_items_in_cart, wp_woocommerce_session_, wp-settings-1, wp-settings-time-1