Homepage › Forums › RetroPie Project › GPIO Adapter, ControlBlock etc. › Pi keeps crashing on boot after ControlBlock software was installed.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • 04/18/2015 at 03:17 #95317
    fantumn
    Participant

    So I just finished installing the ControlBlock software, and then it automatically rebooted. Now it won’t boot fully, it says:

    invoke-rc.d samba reload
    Run during shutdown sequence
    Enabling safemode: initscript
    Policy layer disabled

    I got a picture of the screen right before it crashes, and put it up on imgur here: http://imgur.com/FFL4W94,EXcBx39

    04/18/2015 at 18:30 #95549
    petrockblog
    Keymaster

    According to the screenshot, the system is not crashing, but shutting down properly (from an OSs point of view).

    You need to connect a toggle switch when then ControlBlock service is running. Otherwise the ControlBlock gets a random toggle switch signal.

    04/18/2015 at 19:07 #95550
    fantumn
    Participant

    Thanks for the help! I’ll give that a shot

    04/19/2015 at 06:02 #95590
    fantumn
    Participant

    So that worked! it launches fully now, but the toggle switch only works to shut it down about 1 out of every 4 times I flip it, and it doesn’t seem to be able to turn it back on by itself, did I miss an installation step?

    04/19/2015 at 21:12 #95643
    petrockblog
    Keymaster

    Glad to hear that!
    Could you post a one or two pictures of your setup here? Maybe we can see what might cause the switch behavior.

    04/19/2015 at 21:25 #95646
    fantumn
    Participant

    Yeah, it’ll take me a bit to get the wires in a picture where you can actually tell what’s going on, I’m using a SPDT switch with nothing on the other terminal, but that shouldn’t matter right?

    04/19/2015 at 21:38 #95650
    petrockblog
    Keymaster

    Should work.
    A quite raw way for testing the power switch behavior of the ControlBlock is to just connect the two button pins with each other. This signals the ControlBlock that the switch is turned “on”. When the RPi has booted you can then disconnect the two pins and you should see the RPi being shutdown by the ControlBlock service.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • The forum ‘GPIO Adapter, ControlBlock etc.’ is closed to new topics and replies.