Homepage › Forums › RetroPie Project › Controller Configuration in RetroPie › Can't configure controller.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 03/06/2016 at 10:46 #119288
    elgur85
    Participant

    I tried to configure a USB-NES controller in RetroPie, but something went wrong.
    I tried to remove the config-file in /opt/retropie/configs/all/retroarch-joypads/ in hope that I could end up with “a new gamepad” is connected in RetroPie, but I was wrong.

    How can I do to get this gamepad work as I want to?
    I have the config-file saved on my computer, but pasting that to /opt/retropie/configs/all/retroarch-joypads/ won’t help at all.

    03/06/2016 at 13:24 #119304
    Floob
    Member

    When in Emulation Station you could re-create the file by pressing Start on the controller and entering the Input controller menu.

    03/06/2016 at 14:09 #119314
    elgur85
    Participant

    [quote=119304]When in Emulation Station you could re-create the file by pressing Start on the controller and entering the Input controller menu.

    [/quote]

    And if I cannot enter that menu with my controller?

    03/06/2016 at 16:09 #119327
    ruckage
    Participant

    I think the file you probably need is /home/pi/.emulationstation/es_input.cfg
    Edit this file and delete the section relevant to your controller (make a backup first though just to be on the safe side.)

    Reboot the Pi with you controller connected and it should then hopefully start the controller configuration program.

    Also if you’ve configured emulationstation to work with a keyboard you could just use that to access the input controller menu which would be easier.

    03/06/2016 at 16:28 #119330
    meneerjansen
    Participant

    [quote=119327]Also if you’ve configured emulationstation to work with a keyboard you could just use that to access the input controller menu which would be easier.
    [/quote]
    [off topic] How does one do that? I’d like to be able to control Emulationstation w/ my keyboard. [edit] When looking for the answer for the TS I found it (sudo ~/RetroPie-Setup/retropie_setup.sh And then: “Setup (post install) –> Configure Retroarch controller” (or “Configure keyboard for use w/ Retroarch” to configure a keyboard).). [edit again] That doesn’t work in Emulation station. Only in Retroarch (i.e. when you’ve started a game). => Configure the use of a keyboard in Emulationstation the same way you’d configure a joystick.

    [on topic] If you’ve got a spare controller lying around you could connect that one to your Pi and press ‘Select’ –> ‘Configure input’.

    03/06/2016 at 17:44 #119345
    ruckage
    Participant

    You configure a keyboard in exactly the same way as you do a controller.
    On the configure input menu it asks you to “hold down a key on the device you wish to configure” so just hold down a key on the keyboard.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • The forum ‘Controller Configuration in RetroPie’ is closed to new topics and replies.