Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 03/15/2016 at 13:52 in reply to: Problems getting PS3 controller to work properly #120442
    tinygamer
    Participant

    I figured out now, that my R2 button isn’t working because since I did the steps from gizmo RetroArch doesn’t notice any changes in the controller/joypad-configuration? Is there a possible force update or something like that?

    EDIT: Solved by complete reinstall.

    03/14/2016 at 18:34 in reply to: Problems getting PS3 controller to work properly #120302
    tinygamer
    Participant

    Did you try the 4 steps from gizmo98?

    [quote=119984]Hotfix. Not tested at all but seems to run better:
    Press F4. Emulationstation will close.
    Type…

    cd RetroPie-Setup
    git pull
    sudo ./retropie_packages.sh sdl2
    emulationstation

    Input configuration should work again.[/quote]

    03/12/2016 at 20:27 in reply to: Problems getting PS3 controller to work properly #120123
    tinygamer
    Participant

    @gizmo98: Yes L2 works. I configured my controls, such that L1 and R1 change weapons and I strafe with L2/R2. I may tumbled that. ,:D
    If I would switch that configurations, playing SNES unimpaired might be possible, but this would only be a work-around. :(

    03/12/2016 at 18:13 in reply to: Problems getting PS3 controller to work properly #120116
    tinygamer
    Participant

    Hello Guys,

    I had the same issue, but solved it first via manually changing the config-file.
    It worked fine but someday it didn’t anymore. I followed the steps from gizmo98 and now configuring works fine for me and as I look up the conig file, everything is set up correctly. But then in (for example) DOOM the R2-Button (right bumper) won’t be noticed! Is there a problem with older corrupt configurations and DOOM not noticing the change? Have I to update or reload something=

    Thx for any help! :)

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)