ekdor
Participant
Post count: 71

Update. Just finished my most recent part layout session. I was hoping this was the last one. But I am concerned about the weight. I guess it’ll have more resistance to being pushed against. Also it will come apart into two parts to make moving and transport easier. Guess it will be ok. Possibly I could reduce some of the structural stuff and use a stronger material for that. Make the shelves and hatches a thinner material since they are not all offering direct structural support or stiffening. The shelves do a little.

– amendment. I calculated the area and using the material weight worked out the used area, including the offcuts, to weight around 50kg (110 pounds I think I converted that correctly). I think it’ll be ok given I can split it and it would be strong enough to move with sack truck anyway.

The smaller panel on the right is for the acrylic.