Homepage Forums RetroPie Project Controller Configuration in RetroPie USB SNES Controller – D-Pad not working in games Reply To: USB SNES Controller – D-Pad not working in games

#95559
tombofix
Participant

herbfargus:
I did look at the autoenable feature but I do use a multitude of controllers based on the emulator I’m playing on. Is there a way to specify specific controllers when they are plugged in based on the RetroArch.cfg file?

Floob:
I have re-run it several times, even with all the config files deleted so it recreated a fresh version. The content is listed below:

input_device = “USB gamepad ”
input_driver = “udev”
input_b_btn = “2”
input_y_btn = “3”
input_select_btn = “8”
input_start_btn = “9”
input_up_axis = “-1”
input_down_axis = “+1”
input_left_axis = “-0”
input_right_axis = “+0”
input_a_btn = “1”
input_x_btn = “0”
input_l_btn = “4”
input_r_btn = “5”
input_enable_hotkey_btn = “8”
input_exit_emulator_btn = “9”
input_menu_toggle_btn = “0”
input_load_state_btn = “4”
input_save_state_btn = “5”
input_reset_btn = “2”
input_state_slot_increase_axis = “+0”
input_state_slot_decrease_axis = “-0”