Reply To: Autofire on the axis

[TorVaga]

I recon you mean the retroarch.cfg or am I missing a file retropie.cfg?

At line 470 in /opt/retropie/configs/all/retroarch.cfg I got these lines:

# Joypad buttons.
# Figure these out by using RetroArch-Phoenix or retroarch-joyconfig.
# You can use joypad hats with hnxx, where n is the hat, and xx is a string representing direction. 
# E.g. "h0up"
# input_player1_a_btn = 
# input_player1_b_btn =
# input_player1_y_btn =
# input_player1_x_btn =
# input_player1_start_btn =
# input_player1_select_btn =
# input_player1_l_btn =
# input_player1_r_btn =
# input_player1_left_btn =
# input_player1_right_btn =
# input_player1_up_btn =
# input_player1_down_btn =
# input_player1_l2_btn =
# input_player1_r2_btn =
# input_player1_l3_btn =
# input_player1_r3_btn =

Is this where I should alter the buttons?
And add them once more for player 2 below?
My jstest tells me the same inputs on player 1 and player 2, but on different “levels” js0 for player 1, and js0 for player 2. Do I need to give that input at the start of the lines aswell?

Edit:
Ok. I went into the Retropie UI, and went throught the controller config. Then I was able to play the games with player 1. I could not however use 2 player controller. Then I shut down the system, removed the keyboard, and started up again. I could still use the player 1 buttons, but I was shutting it down again to do some other maintenance. When I turned it on again, I can’t get into the UI at all. Says PANIC: Unable to mount roof fs on unknown block. Do you know what might cause that?
Edit:
Back again after a clean install again. This time I used the 3.0 Beta vs. of Retropie. Now I have configured the joystick and buttons for player 1, but I’m not sure how to proceed to get player 2 working. Neither do I know how I can get those dedicated 1 Player and 2 Player buttons to work.