postman87
Participant
Post count: 9

Hi all,

I’m having this same exact problem with retropie 3.0 beta.
I tried this solution but somewhere in the config.txt there allready is a line that says hdmi_drive=2 . I’m not sure what I’m doing wrong here, so help would be appreciated. My config.txt looks like this. I did not edit anything, it came like this after installing 3.0 beta.

___________________________________________________________________________

# uncomment if you get no picture on HDMI for a default “safe” mode
#hdmi_safe=1

# uncomment this if your display

has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

#

uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if

there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force

a console size. By default it will be display’s size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

#

uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

# for more options see

http://elinux.org/RPi_config.txt
gpu_mem_256=128
gpu_mem_512=256
gpu_mem_1024=256

overscan_scale=1

_____________________________________________________________________

thanks in advance!