Homepage › Forums › RetroPie Project › Controller Configuration in RetroPie › Twin / multiple ps3 via bluetooth › Reply To: Twin / multiple ps3 via bluetooth

11/08/2015 at 21:38 #109416
gizmo98
Participant

Pairing a second controller should be easy. Start your pi. Wait until emulationstation appears. Connect second controller over usb. Wait some seconds. The controller should be configured now. Disconnect and press PS button.

If this does not work please do the following steps. There was a small modification short after 3.2 release. Please press “F4” and type:

cd RetroPie-Setup
git pull
sudo ./retropie_setup.sh

Remove and install driver again.