Reply To: RetroPie 3 beta 4

[dougie1970]

i could not find es_temporaryinput.cfg file as it was not there .

ok this is the file after set up and right and left did not work .

The first joypad configuration file (which we generate),

input_device = “Microsoft X-Box 360 pad”
input_driver = “udev”
input_up = “h0up”
input_right = “h0right”
input_state_slot_increase = “h0right”
input_down = “h0down”
input_left = “h0left”
input_state_slot_decrease = “h0left”
input_a_btn = “0”
input_b_btn = “1”
input_reset_btn = “1”
input_x_btn = “2”
input_menu_toggle_btn = “2”
input_y_btn = “3”
input_r_axis = “+5”
input_save_state_axis = “+5”
input_r2_btn = “5”
input_l3_btn = “9”
input_r3_btn = “10”
input_start_btn = “7”
input_exit_emulator_btn = “7”
input_select_btn = “6”
input_enable_hotkey_btn = “6”
input_l_x_plus_axis = “+0”
input_l_x_minus_axis = “-0”
input_l_y_plus_axis = “+1”
input_l_y_minus_axis = “-1”
input_r_x_plus_axis = “+3”
input_r_x_minus_axis = “-3”
input_r_y_plus_axis = “+4”
input_r_y_minus_axis = “-4”

This is the 2nd file and left and right works fine after removeing the 1st file and going to configure retroarch input devices .

input_device = “Microsoft X-Box 360 pad”
input_driver = “udev”
input_b_btn = “1”
input_y_btn = “3”
input_select_btn = “6”
input_start_btn = “7”
input_up_btn = “h0up”
input_down_btn = “h0down”
input_left_btn = “h0left”
input_right_btn = “h0right”
input_a_btn = “0”
input_x_btn = “2”
input_l_btn = “4”
input_r_btn = “5”
input_l2_axis = “+2”
input_r2_axis = “+5”
input_l3_btn = “9”
input_r3_btn = “10”
input_l_x_plus_axis = “+0”
input_l_x_minus_axis = “-0”
input_l_y_plus_axis = “+1”
input_l_y_minus_axis = “-1”
input_r_x_plus_axis = “+3”
input_r_x_minus_axis = “-3”
input_r_y_plus_axis = “+4”
input_r_y_minus_axis = “-4”
input_enable_hotkey_btn = “6”
input_exit_emulator_btn = “7”
input_menu_toggle_btn = “2”
input_load_state_btn = “4”
input_save_state_btn = “5”
input_reset_btn = “1”
input_state_slot_increase_btn = “h0right”
input_state_slot_decrease_btn = “h0left”

All seems to be working fine again .