Homepage › Forums › RetroPie Project › GPIO Adapter, ControlBlock etc. › Wiring switch for control block.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 04/27/2015 at 13:16 #96287
    shazza6887
    Participant

    Hey guys,

    I ordered the control block with the jumpers and the extra large switch. Just need to know what terminals on the switch i need to use. There are 6 connection areas on the switch. I am assuming the 2 included jumper cables get soldered onto these points. I just need to know on point the brown and black wires go on the switch.

    Cheers

    04/30/2015 at 08:53 #96490
    shazza6887
    Participant

    No one can help with this one?

    05/01/2015 at 18:44 #96612
    petrockblog
    Keymaster

    You need to connect the wires as following:

    wire 1 o o
wire 2 o o
       o o

    The colors and the side do not matter.
    A multimeter would be very helpful here to measure the switch state of the switch :-)

    Hope that helps!

    05/03/2015 at 03:51 #96823
    shazza6887
    Participant

    Thanks mate!

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • The topic ‘Wiring switch for control block.’ is closed to new replies.