Homepage Forums RetroPie Project Controller Configuration in RetroPie Must remove and reconnect USB controllers for emulation use

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #119660
    skewtre
    Participant

    I have a couple of Logitech 310 USB controllers. Using one or both, every time I load a ROM in RetroPie 3.5 OR 3.6, I have to unplug and replug the controllers for them to be seen by the emulator.

    I have tried multiple pi’s, clean installs of everything, and it keeps happening. Everything works fine in the ES menus regardless, but once opening the emulators, I have to unplug (seeing the disconnect message) and replug (seeing the reconnect message).

    Anyone else dealing with this? Suggestions?

    #119682
    herbfargus
    Member

    Tap the top right shoulder button instead of unplugging your controller.

    #119774
    skewtre
    Participant

    This unfortunately had no effect.

    #119775
    herbfargus
    Member

    Try mapping your controller without the top left and right triggers and see if that changes anything

    #119837
    meneerjansen
    Participant

    Some times Retroarch keeps on seeing the wrong controller as the default one (no mater what you set in the setup shell script). I too have to disconnect one of my controllers for a certain controller to work in games that use Retroarch for its config.

Viewing 5 posts - 1 through 5 (of 5 total)
  • The forum ‘Controller Configuration in RetroPie’ is closed to new topics and replies.