Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #104107
    petrdel
    Participant

    Using ControlBlock with 1 joystick & 9 arcade buttons.
    In RetroArch everything works except COIN, START & ESCAPE buttons.
    Anyone have a clue? Here’s my .cfg:

    input_device = “ControlBlock Arcade Gamepad”
    input_driver = “udev”
    input_r_btn = “5”
    input_save_state_btn = “5”
    input_l2_btn = “9”
    input_start_btn = “11”
    input_exit_emulator_btn = “9”
    input_l_btn = “2”
    input_load_state_btn = “2”
    input_up_axis = “-1”
    input_a_btn = “4”
    input_b_btn = “3”
    input_reset_btn = “3”
    input_down_axis = “+1”
    input_right_axis = “+0”
    input_state_slot_increase_axis = “+0”
    input_x_btn = “1”
    input_menu_toggle_btn = “1”
    input_select_btn = “10”
    input_enable_hotkey_btn = “11”
    input_y_btn = “0”
    input_left_axis = “-0”
    input_state_slot_decrease_axis = “-0”

    #104108
    herbfargus
    Member

    Perhaps this may be useful to you:

    https://github.com/RetroPie/RetroPie-Setup/wiki/Can’t-Insert-Coins%3F

    As your input is a gamepad it won’t have an ESC button as that is specific to a keyboard. It functions as the input exit emulator button

    #104111
    petrdel
    Participant

    Thanks…but I’m still lost.
    Would it be easier to redo the CONTROLBLOCK GPIO to “MAME” instead of “ARCADE”?
    Than it’s mapped to KEYBOARD KEYS?

    #104112
    herbfargus
    Member

    I’m not sure I understand the question. For some of the issues they are related to emulators specifically (like lr-mame4all and fba-libretro) if your hotkey button and exit button aren’t working at all with anything then it may be a hardware or config issue. You can see this page for creating custom configurations for individual emulators:

    https://github.com/RetroPie/RetroPie-Setup/wiki/RetroArch-Configuration

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Everything else related to the RetroPie Project’ is closed to new topics and replies.