Homepage › Forums › RetroPie Project › Controller Configuration in RetroPie › Retropie 3.4 and 8bitDo bluetooth Pad › Reply To: Retropie 3.4 and 8bitDo bluetooth Pad

01/23/2016 at 20:16 #114888
hobbswon
Participant

Ok here are the results..

http://pastebin.com/7V7pHpSC

I mapped it through ES and when I did there was a noticeable delay when inputting L2 and R2. But it showed map in the GUI. When I went to check the config they were not mapped in retroarch. It also mapped decrease/increase state to Dpad L/R.

So I manually added the L2 and R2 to the cfg, which mapped as buttons 8 and 9 respectively, and then switched the decrease and increase state to correspond. And it worked fine.

So the only controls that do not work are the analog sticks (and buttons)